Well, the dodecahedron did not turn out. It got off in the middle somewhere and never recovered. I came in the next morning to find a nice bottom half and a big tangle of messy strands of plastic all over the top and sides. According to a web entry, this model printed without supports on […]
More...
After telling Cura to use a raft and put in supports everywhere, I was able to print a knot! I got a very nice 5_1 knot. I also started a dodecahedron printing.
More...
My basic SD card holder printed nicely. It only holds the cards loosely, but that is good enough for my needs. I figured I could put this holder into an envelope or something like that to keep the cards from falling out, but it turns out that it just fits into a paper clip box. […]
More...